How the build went
Use these notes with the video. Repeated chapter links start at the relevant section, not at each individual action.
Start at the strap comparison
The relevant chapter begins at 09:51. I compared a black and silver NATO with a Marlin-clasp bracelet on my MDV-106. The earlier lens work is a separate, more involved job.
Watch from 09:51 ↗Confirm the end-link fit
Ask the seller to confirm the exact MDV-106 fit before ordering. This installation does not establish fit on the smaller MDV-10 or other Duro variants. Check the end links seat properly before wearing it.
Watch from 09:51 ↗Size using the bracelet’s pin system
The bracelet in the video uses push-out sizing pins. I planned to remove links from both sides. That is not a universal link count for every wrist. Check the arrows and instructions for the bracelet you receive.
Watch from 09:51 ↗Check the clasp and final fit
The demonstrated clasp has a button release and a safety closure. Check both work and that the bracelet sits securely without pinching. I show the finished options from 11:55.
Watch from 11:55 ↗
Where it can get awkward
A sizing pin will not move
Stop and confirm the direction and pin type for your exact bracelet. A push-out sizing pin is different from a spring bar. Do not keep tapping without a supported, aligned link.
The end link leaves a gap or will not seat
Check with the seller before forcing it. The demonstrated MDV-106 installation does not prove compatibility with every Duro case.
The bracelet feels too heavy
The NATO shown in the same chapter is an alternative. This guide does not assign a measured weight or long-term comfort score to either option.
Tools to check first
A suitable supported pin-removal setup is needed for the bracelet’s sizing pins. A spring-bar tool may be needed for fitting. Check your existing tools and the bracelet kit before ordering more.
Push pins, spring bars and sizing pins explained →
Before wearing it
- Check the spring bars and end links are seated.
- Check every resized link pin is secure according to the bracelet instructions.
- Close and check both the main clasp and safety closure before wearing it out.
Your pre-build checklist
Saved on this device. These checks are also included in your copied plan.
Evidence & current fit notes
Hands-on source: Original GOAT Reviews build ↗. Watch my original build and use the chapter links above to see how each step went.
Current seller status: The historical route is for the Marlin bracelet. Current end-link variant, included tools and stock are not independently verified. Ask for MDV-106 fit explicitly.
External references were checked on 12 October 2026. I’ve labelled the maker’s current guidance separately from what I tried myself. I haven’t pressure-tested these modified watches.
Found a changed part or broken link? Leave a correction on the original video ↗ with the model and listing details. Avoid posting personal information.
Back to the build shelf →